****************************************************** * * $Id: blk_stmt.txt 498 2011-11-03 13:25:12Z gbc $ * * This file describes which statement names * belong in which $block. An asterisk in the * first column indicates a comment. All block names * and all names must be left-justified. * Blank lines are not allowed. * ****************************************************** $OVEX_REV rev ****************************************************** $GLOBAL ref ****************************************************** $STATION def enddef ref ****************************************************** $MODE def enddef ref ****************************************************** $SCHED scan endscan start mode source station fourfit_reftime ****************************************************** $ANTENNA def enddef antenna_diam antenna_name axis_type axis_offset antenna_motion pointing_sector ****************************************************** $BBC def enddef BBC_assign ****************************************************** $CLOCK def enddef clock_early ****************************************************** $DAS def enddef record_transport_type electronics_rack_type number_drives headstack record_density tape_length recording_system_ID record_transport_name electronics_rack_ID electronics_rack_name tape_motion tape_control ****************************************************** $EOP def enddef TAI-UTC A1-TAI eop_ref_epoch num_eop_points eop_interval ut1-utc x_wobble y_wobble ****************************************************** $EXPER def enddef exper_num exper_name exper_description exper_nominal_start exper_nominal_stop PI_name PI_email contact_name contact_email scheduler_name scheduler_email target_correlator ****************************************************** $FREQ def enddef chan_def switching_cycle sample_rate ****************************************************** $HEAD_POS def enddef headstack_pos ****************************************************** $IF def enddef if_def ****************************************************** $PASS_ORDER def enddef pass_order S2_group_order ****************************************************** $PHASE_CAL_DETECT def enddef phase_cal_detect ****************************************************** $PROCEDURES def enddef tape_change headstack_motion new_source_command new_tape_setup setup_always parity_check tape_prepass preob_cal midob_cal postob_cal procedure_name_prefix ****************************************************** $ROLL def enddef roll roll_def roll_inc_period roll_reinit_period ****************************************************** $SEFD def enddef sefd_model sefd ****************************************************** $SITE def enddef site_type site_name site_ID site_position site_position_ref site_velocity horizon_map_az horizon_map_el zen_atmos ocean_load_vert ocean_load_horiz occupation_code inclination eccentricity arg_perigee ascending_node mean_anomaly semi_major_axis mean_motion orbit_epoch mk4_site_ID ****************************************************** $SOURCE def enddef source_type source_name IAU_name source_position_ref ra dec ref_coord_frame ra_rate dec_rate source_position_epoch source_model inclination eccentricity arg_perigee ascending_node mean_anomaly semi_major_axis mean_motion orbit_epoch ****************************************************** $TAPELOG_OBS def enddef VSN ****************************************************** $TRACKS def enddef fanout_def fanin_def track_frame_format data_modulation bits/sample multiplex_ratio VLBA_frmtr_sys_trk VLBA_trnsprt_sys_trk S2_recording_mode S2_data_source ****************************************************** **** The following blocks are specific to CVEX ******* ****************************************************** $CVEX_REV rev ****************************************************** $CORR_CONFIG def enddef ref ignore_chan_names auto_corr ****************************************************** $CORR_MODE def enddef board cross_pol_chan_pair ****************************************************** $CORR_BD_PARMS def enddef accum_divide_ratio shsmp_divide_ratio sample_count_per_lag_enable ****************************************************** $CORR_SECTION_MODE def enddef chip ****************************************************** $CORR_CHIP_MODE def enddef block snake ****************************************************** $CORR_BLOCK_MODE def enddef rotator_mode xdelay ydelay tap_motion_enable invalid_on_tap_motion header_mode ****************************************************** **** The following blocks are specific to SVEX ******* ****************************************************** $SVEX_REV rev ****************************************************** $SU_CONFIG def enddef ref ****************************************************** $SU_CHAN_OUT def enddef channel_out_assignment ****************************************************** $PCM_CONFIG def enddef phase_cal ****************************************************** $PCM_TABLES def enddef table_values tabular_delta_phase ****************************************************** **** The following blocks are specific to IVEX ******* ****************************************************** $IVEX_REV rev ****************************************************** $CORR_INIT def enddef ref system_tempo bocf_period header_duration CUCC_serial_ports start_stop_counter analog_switch CF_edit_mask timing_monitor ****************************************************** $PBS_INIT def enddef ref SU_ID SUCC_serial_ports tape_servo_interval timing_monitor ****************************************************** $DRIVE_INIT def enddef drive_type mcb_address capstan_relative_diameter vacuum_setting tape_acceleration headstack/DIM_connect monitor_module_track headstack_parms ****************************************************** $TRM_CONFIG def enddef TRM_order_within_channel parity_error_limit invalid_frame_control ****************************************************** $SU/CORR_CONNECT def enddef SU_connect ****************************************************** **** The following blocks are specific to EVEX ******* ****************************************************** $EVEX_REV rev ****************************************************** $EVEX def enddef ref corr_exp# ovex_file cvex_file svex_file lvex_file AP_length speedup_factor tape_mode mirror realtime_latency ****************************************************** **** The following blocks are specific to LVEX ******* ****************************************************** $LVEX_REV rev ****************************************************** $LOG def enddef scan endscan VSN disc_set disc_serial disc_model disc_size head_pos start_tape stop_tape start_disc stop_disc source autopeak_interval pass ******************************************************